Get started with ZealCast's Director
Find your way around ZealCast: the tabs, PROGRAM and PREVIEW, your camera sources, CUT and AUTO, and scenes.
ZealCast turns an iPad (or iPhone) into a live video switcher. You pick shots from your cameras, put them on air, and stream or record the result.
The tabs
ZealCast has five tabs along the bottom:
- Director is where you run the service.
- Sources lists the cameras ZealCast can see.
- Scenes is where you build layouts that combine several sources.
- Crew shows the devices in your session, crew messages and remote cameras.
- Settings holds stream destinations, video quality, your logo, your Zeal account and more.
PROGRAM and PREVIEW
Director shows two monitors. PROGRAM is what is on air right now. PREVIEW is the shot you are getting ready to show next.
Tap a source tile and it goes to PREVIEW. Nothing changes on air until you take it.
Your sources
Your sources appear in Director under the Sources heading:
- Built-in Camera is always there. If it shows Tap to activate, tap it to start the camera.
- Every NDI camera on your network appears as its own tile. This includes phones running ZealLens and ZealPresenter's NDI output.
If you see Scanning for NDI… or No NDI sources found, make sure the cameras are on the same network as this iPad, then tap the refresh arrow beside the Sources heading.
A ZealLens camera shows its battery level on its tile. When the battery is at 20% or below, the tile reads LOW before the percentage.
CUT and AUTO
- CUT puts PREVIEW on air instantly.
- AUTO puts PREVIEW on air using the transition you have chosen.
Both buttons are dimmed until something is in PREVIEW.
To choose the transition, tap the transition button next to LYRICS. Pick Cut, Fade, Wipe Left, Wipe Right, Wipe Up, or Wipe Down. For anything other than Cut, you can also pick a duration.
Scenes
A scene shows several sources at once. To make one:
- Open the Scenes tab and tap Add Scene.
- Give it a name and choose a layout: Single, Split, PiP or Quad.
- Tap Add, then tap the scene to open it.
- Tap each empty slot (Tap to assign) and choose a camera.
Your scenes appear above the sources in Director. Tap one to load it into PREVIEW, then use CUT or AUTO.
A scene can have its own transition. When a scene with its own transition is in PREVIEW, AUTO uses that transition instead of the one in Director, and a small Scene: label tells you so. CUT is always a cut.
Next steps
- Set up a stream destination and go live.
- Open the mixer to bring up the sound from your cameras. Open the mixer to bring up the sound from your cameras; new sources arrive muted.