Mix your sound in ZealCast
Bring up camera sound in ZealCast's mixer: why new sources arrive muted, faders in dB, mute, SOLO in your headphones, and pinning strips.
ZealCast mixes the sound from the iPad's microphone and from every NDI source on your network. That mix is what goes to your stream, your recording and ZealCast's NDI output.
Open the mixer
Director has an audio strip with a meter and a mute button for each source. Tap Audio to show or hide the strip.
For the full mixer, tap Mixer on the audio strip, or tap the more button (a circle with three dots) and choose Advanced Mixer.
New sources arrive muted
When a new NDI source appears on the network, its channel starts muted. This stops a room full of camera microphones from going on air without anyone choosing them.
To bring a source into the mix, unmute it. ZealCast remembers each source by name, so a camera you unmuted last week comes back unmuted. Only sources with a new name arrive muted.
Faders, mute and the status chip
Each channel in the Advanced Mixer has a vertical fader with its level shown in dB underneath. 0.0 dB is unity gain, and −∞ means the fader is all the way down.
- MUTE takes the channel out of the mix.
- The chip at the top of each strip tells you what that channel is doing: IN MIX, MUTED, NOT IN MIX, SOLO or −∞. The master reads MAIN.
- PGM under a camera's name means that camera's picture is on PROGRAM. A camera's sound stays in the mix whether or not its picture is on air.
A source that is not sending any sound reads "—" rather than showing a level.
SOLO and headphones
SOLO lets you listen to one channel on its own in your headphones without changing what goes on air. It never changes what goes on air. Your stream, recording and NDI output keep the full program mix.
Tap SOLO again to return to the program mix. When nothing is soloed, your headphones hear the full program.
Two things to know:
- SOLO is not saved. When you reopen ZealCast, nothing is soloed.
- Soloing a channel that is muted or has its fader down is silent, because a channel reaches the headphones after its own fader and mute.
Pin the channels you use most
Tap the pin on a strip to keep it at the left of the mixer, where it stays in reach however many sources are on the network. You can pin up to four channels. The master always sits at the right edge.
More tools
The Advanced Mixer also has:
- EQ, CMP (compressor) and FX (reverb and delay) for each channel
- Auto-Ducking, which lowers your NDI and video sources while the iPad's microphone picks up someone speaking
- Short-term and integrated loudness in LUFS, with Reset LUFS
- Routing, where you can exclude a channel from the program mix while keeping it in other outputs
The Advanced Mixer is free and is not part of ZealCast Pro.